Lacp Agg Actor System Priority - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Link Aggregation Commands

lacp agg actor system priority

Configures the system priority of the port on the switch that belongs to the dynamic aggregate group.
lacp agg [ethernet | fastethernet | gigaethernet] slot/port actor system priority actor_system_priority
lacp agg [ethernet | fastethernet | gigaethernet] slot/port no actor system priority
Syntax Definitions
ethernet
fastethernet
gigaethernet
slot
port
actor_system_priority
Defaults
parameter
actor_system_priority
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
Use the no form of this command to remove an actor system priority value from a slot and port associ-
ated with a dynamic aggregate group.
•
The ethernet, fastethernet, and gigaethernet keywords do not modify a port's configuration. See
Chapter 1, "Ethernet Port Commands,"
Examples
-> lacp agg ethernet 3/2 actor system priority 65
-> lacp agg ethernet 3/2 no actor system priority
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
Documents that the port is 10 Mbps Ethernet.
Documents that the port is 100 Mbps Fast Ethernet.
Documents that the port is Gigabit Ethernet.
The slot number for this aggregate.
The port that the switch will initially use as the Spanning Tree virtual
port for this aggregate.
The priority of the dynamic aggregate group. Possible values are
0–255.
default
0
for information on CLI commands to configure Ethernet ports.
June 2012 page 8-29