Display Gvrp Status - 3Com S7906E Command Reference Manual

Default Level
1: Monitor level
Parameters
interface interface-list: Defines one or multiple Ethernet ports. You can provide up to 10 Ethernet port
lists, by each of which you can specify an individual port in the form of interface-type interface-number,
or a port range in the form of interface-type interface-number1 to interface-type interface-number2,
where the end-port number specified by interface-number2 must be greater than the start-port number
specified by interface-number1. If no ports are specified, this command displays the GVRP statistics for
all trunk ports.
Description
Use the display gvrp statistics command to display the GVRP statistics of specified or all trunk ports.
Note that if the interface interface-list is not provided, the GVRP statistics of all trunk ports will be
displayed. Otherwise, only the GVRP statistics of all the specified trunk port will be displayed.
Examples
# Display statistics about GVRP for trunk port GigabitEthernet 2/0/1.
<Sysname> display gvrp statistics interface GigabitEthernet 2/0/1
GVRP statistics on port GigabitEthernet2/0/1
Table 1-2 display gvrp statistics command output description
Field
GVRP Status
GVRP Running
GVRP Failed Registrations
GVRP Last Pdu Origin
GVRP Registration Type

display gvrp status

Syntax
display gvrp status
View
Any view
GVRP Status
GVRP Running
GVRP Failed Registrations
GVRP Last Pdu Origin
GVRP Registration Type
Indicates whether GVRP is enabled or disabled.
Indicates whether GVRP is running.
Indicates the number of GVRP registration failures.
Indicates the source MAC address in the last GVRP PDU.
Indicates the GVRP registration type on the port.
: Enabled
: YES
: 0
: 0000-0000-0000
: Normal
Description
1-7