Lldp Management-Address-Tlv; Lldp Notification Remote-Change Enable - 3Com S7906E Command Reference Manual

[Sysname] interface gigabitethernet2/0/3
[Sysname-GigabitEthernet2/0/3] lldp management-address-format string

lldp management-address-tlv

Syntax
lldp management-address-tlv [ ip-address ]
undo lldp management-address-tlv
View
Ethernet interface view, port group view
Default level
2: System level
Parameters
ip-address: Management address to be set.
Description
Use the lldp management-address-tlv command to enable the management address sending. This
command also sets the management address.
Use the undo lldp management-address-tlv command to disable management address sending.
By default, the management address is sent through LLDPDUs, and the management address is the
primary IP address of the VLAN with the least VLAN ID among the VLANs whose packets are permitted
on the port. If the primary IP address is not configured, the management address is 127.0.0.1. For
information about VLAN, refer to VLAN Configuration in the Access Volume.
Note that an LLDPDU carries only one management address. If you set the management address
repeatedly, the latest one takes effect.
Examples
# Set the management address to 192.6.0.1 for GigabitEthernet2/0/3.
<Sysname> system-view
[Sysname] interface gigabitethernet2/0/3
[Sysname-GigabitEthernet2/0/3] lldp management-address-tlv 192.6.0.1

lldp notification remote-change enable

Syntax
lldp notification remote-change enable
undo lldp notification remote-change enable
View
Ethernet interface view, port group view
1-22