3Com S7906E Command Reference Manual page 123

Parameters
interface-type interface-number: Port type and port number.
to: Specifies an interface range in the form of interface-type interface-number to interface-type
interface-number, where the start interface number must be smaller than the end interface number.
Note that both the start interface and the end interface are inclusive.
Description
Use the display link-aggregation member-port command to display the detailed link aggregation
information of the specified interface(s) or all interfaces if no interface is specified.
For an interface in a static aggregation group, only its port number and operational key are displayed,
because it is not aware of the information of the partner.
Examples
# Display the detailed link aggregation information of Ethernet 2/0/1, which is in a static aggregation
group.
<Sysname> display link-aggregation member-port ethernet 2/0/1
Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,
G -- Defaulted, H -- Expired
Ethernet2/0/1:
Aggregation Interface: Bridge-Aggregation1
Port Number: 1
Oper-Key: 1
# Display the detailed link aggregation information of Ethernet 2/0/2, which is in a dynamic aggregation
group.
<Sysname> display link-aggregation member-port ethernet 2/0/2
Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,
G -- Defaulted, H -- Expired
Ethernet2/0/2:
Aggregation Interface: Bridge-Aggregation10
Local:
Port Number: 2
Port Priority: 32768
Oper-Key: 2
Flag: {ACDEF}
Remote:
System ID: 0x8000, 000f-e267-6c6a
Port Number: 26
Port Priority: 32768
Oper-Key: 2
Flag: {ACDEF}
1-3