Epon-Parameter Ouilist - 3Com S7906E Command Reference Manual

Examples
# Configure the key update time and encryption reply timeout time for the EPON card in slot 3 as 20
seconds and 5 seconds (50 × 100 ms) respectively.
<Sysname> system-view
[Sysname] ftth
[Sysname-ftth] encryption timer update-time 20 no-reply-timeout 50 slot 3

epon-parameter ouilist

Syntax
epon-parameter ouilist { oui oui-value oam-version version-value } &<1-9> slot slot-number
undo epon-parameter ouilist slot slot-number
View
FTTH view
Default Level
2: System level
Parameters
oui-value: OUI (Organizationally Unique Identifier) of the ONU.
version-value: OAM (Operation, Administration and Maintenance) version number of the ONU.
&<1-9>: Indicates that you can specify up to 9 OUI values/OAM version numbers.
slot-number: Slot number of the EPON card.
Description
Use the epon-parameter ouilist command to configure the OUI and extended OAM version number of
the ONU in the specified slot.
Use the undo epon-parameter ouilist command to cancel the configuration.
By default, the OUI and extended OAM version number are 111111 and 1 respectively. After this
configuration, an H3C ONU attached to an OLT goes online after being bound with the specified ONU
port (The OUI and extended OAM version number for an H3C ONU are 111111 and 1 respectively).
Note the following:
Entries with the same OUIs and extended OAM version numbers cannot be not configured at the
same time on one EPON card.
When the OUI and extended OAM version number list of an EPON card changes (when a list is
configured or canceled), all the ONUs under the EPON card will reregister.
Related commands: display epon-parameter.
Examples
# Configure the OUI and extended OAM version number of the ONU connected to the EPON card in
slot 3.
<Sysname> system-view
[Sysname] ftth
1-20