Ip Subnet-Based Vlan Configuration Commands; Display Ip-Subnet-Vlan Interface - 3Com S7906E Command Reference Manual

To use 802.3 encapsulation, use the command:
[Sysname-vlan3] protocol-vlan mode snap etype 0806

IP Subnet-Based VLAN Configuration Commands

display ip-subnet-vlan interface

Syntax
display ip-subnet-vlan
interface-number2 | all }
View
Any view
Default Level
2: System level
Parameters
interface-type interface-number1: Specifies a port by its type and number.
interface-type interface-number1 to Interface-type interface-number2: Specifies multiple ports.
all: Displays IP subnet-based VLAN information about all the ports with IP subnet-based VLAN
configured.
Description
Use the display ip-subnet-vlan interface command to display IP subnet-based VLANs and IP subnet
indexes on the specified port(s).
Examples
# Display IP subnet-based VLANs and IP subnet indexes on GigabitEthernet 2/0/1.
<Sysname> system-view
[Sysname]display ip-subnet-vlan interface gigabitethernet2/0/1
Interface: GigabitEthernet2/0/1
VLAN ID Subnet-Index
=======================================================
3
Table 1-6 display ip-subnet-vlan interface command output description
Interface
VLAN ID
Subnet-Index
IP ADDRESS
NET MASK
interface {
IP ADDRESS
0 192.168.1.0
Field
interface-type interface-number1
NET MASK
255.255.255.0
Interface of which you want to view the
information
VLAN ID
Index of the IP subnet
IP address of the subnet (either an IP address or
a network address)
Mask of the IP subnet
1-28
[ to interface-type
Description