Display Rip Route - 3Com S7906E Command Reference Manual

Version
MetricIn
MetricIn route policy
MetricOut
MetricOut route policy
Split-horizon
Poison-reverse
Input/Output
Default route
Current packets number/Maximum
packets number

display rip route

Syntax
display rip process-id route [ statistics | ip-address { mask | mask-length } | peer ip-address ]
View
Any view
Default Level
1: Monitor level
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
statistics: Displays the route statistics, including total number of routes and number of routes of each
neighbor.
ip-address { mask | mask-length }: Displays route information about a specified IP address.
peer ip-address: Displays all routing information learned from a specified neighbor.
Description
Use the display rip route command to display the routing information of a specified RIP process.
Examples
# Display all routing information of RIP process 1.
<Sysname> display rip 1 route
Field Description
RIP version running on the interface
Additional routing metric added to the incoming routes
Name of the routing policy used to add the additional
routing metric for the incoming routes. If no routing policy is
referenced, the field displays Not designated.
Additional routing metric added to the outgoing routes
Name of the routing policy used to add the additional
routing metric for the outgoing routes. If no routing policy is
referenced, the field displays Not designated.
Indicates whether split-horizon is enabled (ON: enabled,
OFF: disabled)
Indicates whether poison-reverse is enabled (ON: enabled,
OFF: disabled)
Indicates if the interface is allowed to receive (Input) or
send (Output) RIP messages (on means it is allowed, off
means it is not allowed)
Default route
Packets to be sent/Maximum packets that can be sent on
the interface
1-7