Display Cfd Ma - 3Com S7906E Command Reference Manual

Table 1-6 display cfd linktrace-reply auto-detection command output description
Field
Service instance
MEP ID
Time
Target MEP ID
TTL
MAC Address
TTL
Forwarded
Relay Action

display cfd ma

Syntax
display cfd ma [ [ ma-name ] md md-name ]
View
Any view
Default level
2: System level
Parameters
ma-name: Name of MA, ranging from 1 to 48 characters, composed of letters, numbers or underlines,
but cannot start with an underline character.
md md-name: Specifies the name of an MD, ranging from 1 to 48 characters, composed of letters,
numbers or underlines, but cannot start with an underline character.
Description
Use the display cfd ma command to display the configuration of a specified MA.
Note that:
If MD is not specified, this command will display the MA configurations of all MDs on the device.
If both MD and MA are specified, this command will display the specified MA configuration.
If only MD is specified, this command will display the configurations of all MAs in that MD.
Examples
# Display the MA configuration information.
Service instance to which the MEPs that sent LTM messages belong
ID of the MEP that sends LTMs
Time of the LTMs automatically sent
ID of the target MEP
Initial hop count of the automatically sent LTMs
Source MAC address in the LTR messages
Hop count when LTM passes the device
Yes means that the device has forwarded the LTMs.
No means that the device did not forward the LTMs.
Found: Indicates that the forwarding device found the destination MAC
address in its MAC address table.
Unknown: Indicates that the forwarding device failed to find the
destination MAC address in its MAC address table.
None: Indicates that it is a MEP that responded to the LTM message. A
MEP does not need to find the destination MAC address.
1-14
Description