3Com S7906E Command Reference Manual page 456

Ring Level : 1
Node Mode : Edge
Active Status : No
Common port : GigabitEthernet3/0/3
Packet Link
Direct Hello Down
------------------------------------------------------------------------
Send 0 0
Rcv 0 0
Common port : GigabitEthernet3/0/4
Packet Link
Direct Hello Down
------------------------------------------------------------------------
Send 0 0
Rcv 0 0
Edge port : GigabitEthernet3/0/5
Packet Link
Direct Hello Down
------------------------------------------------------------------------
Send 0 0
Rcv 0 0
Table 1-3 display rrpp statistics command output description
Field
Ring ID
Ring Level
Node Mode
Active Status
Primary Port
Secondary Port
Common Port
Edge Port
Packet Direct
Hello
Common Complete
Flush FDB Flush FDB
0 0
0 0
Common Complete
Flush FDB Flush FDB
0 0
0 0
Common Complete
Flush FDB Flush FDB
0 0
0 0
RRPP ring ID
RRPP ring level: 0 for primary ring and 1 for subring
Node mode: master node, transit node, edge node and assistant
edge node
RRPP ring activation status: Yes indicates active and No indicates
inactive (An RRPP is active only if the RRPP ring is enabled and the
RRPP protocol is globally enabled)
The primary port field means the node mode is master node or transit
node. "-" appears when the port is not configured on the ring or the
board to which the port belongs does not start, and in this case, no
corresponding statistics appears.
The secondary port field means the node mode is master node or
transit node. "-" appears when the port is not configured on the ring or
the board to which the port belongs does not start, and in this case, no
corresponding statistics appears.
The common port field means the node mode is edge node or
assistant edge node. "-" appears when the port is not configured on
the ring or the board to which the port belongs does not start, and in
this case, no corresponding statistics appears.
The edge port field means the node mode is edge node or assistant
edge node. "-" appears when the port is not configured on the ring or
the board to which the port belongs does not start, and in this case,
no corresponding statistics appears.
Packet transmission direction on the port: Send or Rcv
Hello packet statistics received/sent on the port
1-6
Edge Major Packet
Hello Fault Total
0 0 0
0 0 0
Edge Major Packet
Hello Fault Total
0 0 0
0 0 0
Edge Major Packet
Hello Fault Total
0 0 0
0 0 0
Description