Host-Route; Import-Route (Rip View) - 3Com S7906E Command Reference Manual

6300 series
Hide thumbs Also See for S7906E:
Table of Contents

Advertisement

[Sysname-rip-1] filter-policy 2000 import
# Reference IP prefix list abc on Vlan-interface 1 to filter all received RIP routes.
[Sysname-rip-1] filter-policy ip-prefix abc import Vlan-interface 1

host-route

Syntax
host-route
undo host-route
View
RIP view
Default Level
2: System level
Parameters
None
Description
Use the host-route command to enable host route reception.
Use the undo host-route command to disable host route reception.
By default, receiving host routes is enabled.
In some cases, a router may receive many host routes from the same network segment. These routes
are not helpful for routing and occupy a large amount of network resources. You can use the undo
host-route command to disable receiving of host routes.
RIPv2 can be disabled from receiving host routes, but RIPv1 cannot.
Examples
# Disable RIP from receiving host routes.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] undo host-route

import-route (RIP view)

Syntax
import-route protocol [ process-id | all-processes | allow-ibgp ] [ cost cost | route-policy
route-policy-name | tag tag ] *
1-11

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

S7910eS7906e-vS7903eS7903e-sS7902e

Table of Contents