Reset Dldp Statistics - 3Com S7906E Command Reference Manual

View
System view
Default Level
2: System level
Parameters
enhance: Specifies the enhanced DLDP mode. When a device operates in this mode and a neighbor
entry it maintains expires, the device detects the neighbor before removing the neighbor entry.
normal: Specifies the normal DLDP mode. When a device operates in this mode and a neighbor entry it
maintains expires, the device removes the neighbor entry directly.
Description
Use the dldp work-mode command to set the DLDP mode.
Use the undo dldp work-mode command to restore the default DLDP mode.
By default, a device operates in normal DLDP mode.
Note that:
In normal DLDP mode, only fiber cross-connected unidirectional links can be detected.
In enhanced DLDP mode, two types of unidirectional links can be detected. One is fiber
cross-connected links. The other refers to fiber pairs with one fiber not connected or disconnected.
The support for these two commands varies with device models.
Examples
# Configure the device to operate in enhanced DLDP mode.
<Sysname> system-view
[Sysname] dldp work-mode enhance

reset dldp statistics

Syntax
reset dldp statistics [ interface-type interface-number ]
View
User view
Default Level
1: Monitor level
1-9