Ospf Cost - 3Com S7906E Command Reference Manual

Examples
# Configure the network 131.119.0.0/16 in Area 1 to support MD5 cipher authentication, and set the
interface key ID to 15, authentication password to abc, and password type to cipher.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] area 1
[Sysname-ospf-100-area-0.0.0.1] network 131.119.0.0 0.0.255.255
[Sysname-ospf-100-area-0.0.0.1] authentication-mode md5
[Sysname-ospf-100-area-0.0.0.1] quit
[Sysname-ospf-100] quit
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospf authentication-mode md5 15 cipher abc
# Configure the network 131.119.0.0/16 in Area 1 to support simple authentication, and set for the
interface the authentication password to abc, and password type to cipher.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] area 1
[Sysname-ospf-100-area-0.0.0.1] network 131.119.0.0 0.0.255.255
[Sysname-ospf-100-area-0.0.0.1] authentication-mode simple
[Sysname-ospf-100-area-0.0.0.1] quit
[Sysname-ospf-100] quit
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospf authentication-mode simple cipher abc

ospf cost

Syntax
ospf cost value
undo ospf cost
View
Interface view
Default Level
2: System level
Parameters
value: OSPF cost, in the range 1 to 65535.
Description
Use the ospf cost command to set an OSPF cost for the interface.
Use the undo ospf cost command to restore the default.
By default, an OSPF interface calculates its cost with the formula: interface default OSPF cost=100
Mbps/interface bandwidth(Mbps). Default OSPF costs of some interfaces are:
1785 for the 56 kbps serial interface
1-47