Display Interface Vlan-Interface - 3Com S7906E Command Reference Manual

[Sysname-Vlan-interface2] description VLAN-INTERFACE-2

display interface vlan-interface

Syntax
display interface vlan-interface [ vlan-interface-id ]
View
Any view
Default Level
1: Monitor level
Parameters
vlan-interface-id: VLAN interface number.
Description
Use the display interface vlan-interface command to display information about a specified or all
VLAN interfaces if no interface is specified.
Related commands: interface vlan-interface.
Examples
# Display the information of VLAN-interface 2.
<Sysname> display interface vlan-interface 2
Vlan-interface2 current state: UP
Line protocol current state: UP
Description: Vlan-interface2 Interface
The Maximum Transmit Unit is 1500
Internet Address is 192.168.0.72/24 Primary
IP Packet Frame Type: PKTFMT_ETHNT_2,
IPv6 Packet Frame Type: PKTFMT_ETHNT_2,
Table 1-1 display interface vlan-interface command output description
Field
Vlan-interface2 current state
Hardware Address: 0000-fc00-6505
Hardware Address: 0000-fc00-6505
The physical state of the VLAN interface, which can be one of the
following:
Administratively DOWN: The administrative state of the VLAN
interface is down because it has been manually shut down with
the shutdown command.
DOWN: The administrative state of this VLAN interface is up,
but its physical state is down. It indicates that the VLAN
corresponding to this interface does not contain any port in the
UP state (possibly because the ports are not well connected or
the lines have failed).
UP: both the administrative state and the physical state of this
VLAN interface are up.
1-2
Description