Region-Name; Reset Stp - 3Com S7906E Command Reference Manual

region-name

Syntax
region-name name
undo region-name
View
MST region view
Default Level
2: System level
Parameters
name: MST region name, a string of 1 to 32 characters.
Description
Use the region-name command to configure the MST region name of your device.
Use the undo region-name command to restore the default MST region name.
By default, the MST region name of a device is its MAC address.
The MST region name, the VLAN-to-MSTI mapping table and the MSTP revision level of a device jointly
determine the MST region the device belongs to.
Related commands: instance, revision-level, check region-configuration, vlan-mapping modulo,
active region-configuration.
Examples
# Set the MST region name of the device to "hello".
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] region-name hello

reset stp

Syntax
reset stp [ interface interface-list ]
View
User view
Default Level
1: Monitor level
Parameters
interface interface-list: Specifies an Ethernet port list, in the format of interface-list = { interface-type
interface-number [ to interface-type interface-number ] }&<1-10>, where &<1-10> indicates that you
can specify up to 10 ports or port ranges.
1-12