Display Onu-Protocol - 3Com S7906E Command Reference Manual

Table 2-2 display epon-multicast information command output description
ONU is not in multicast-control mode.
Multicast-control information: None.
UNI number 1
Multicast vlan 10
Current channel list
multicast ip
status:permit
preview times:16
preview remain time:144s

display onu-protocol

Syntax
display onu-protocol [ stp | igmp-snooping | dhcp-snooping information ]
View
ONU port view
Default Level
2: System level
Parameters
stp: Displays the information about RSTP supported by the ONU.
igmp-snooping: Displays the information about IGMP snooping supported by the ONU.
dhcp-snooping information: Displays the information about DHCP-Snooping Option82 supported by
the ONU.
Description
Use the display onu-protocol command to display the information about the protocols supported by
an ONU that is in up state.
Field
2-6
Description
The multicast control mode of the ONU is IGMP
snooping. No multicast control information is
available now.
The multicast control mode of the ONU is
multicast control mode but no multicast control
information is generated. There are two reasons
for this:
No multicast control contents are configured.
The multicast client sends no IGMP report
message.
UNI port number
Multicasts VLAN number
List of current multicast channels
Multicast IP address of multicast channel
Multicast control policy
permit: Allows access to the corresponding
multicast channel (without time limit).
preview: Allows previewing the corresponding
multicast channel (with time limit)
This is the sixteenth time the corresponding
multicast channel has been previewed.
The channel can be previewed for 144 more
seconds before the preview ends.