Display Ospf Error - 3Com S7906E Command Reference Manual

Intra Area
Inter Area
ASE

display ospf error

Syntax
display ospf [ process-id ] error
View
Anyview
Default Level
1: Monitor level
Parameters
process-id: OSPF process ID, in the range 1 to 65535.
Description
Use the display ospf error command to display OSPF error information.
If no process is specified, the OSPF error information of all OSPF processes is displayed.
Examples
# Display OSPF error information.
<Sysname> display ospf error
OSPF Process 1 with Router ID 192.168.80.100
0 : OSPF Router ID confusion
0 : OSPF bad version
0 : OSPF bad area ID
0 : OSPF bad virtual link
0 : OSPF bad authentication key
0 : OSPF Neighbor state low
0 : OSPF interface down
0 : HELLO: Netmask mismatch
0 : HELLO: Dead timer mismatch
0 : HELLO: NBMA neighbor unknown 0
0 : DD: Unknown LSA type
0 : LS ACK: Bad ack
0 : LS REQ: Empty request
0 : LS UPD: LSA checksum bad
0 : LS UPD: Unknown LSA type
Field
OSPF Packet Error Statistics
Intra-area route number
Inter-area route number
ASE route number
0 : OSPF bad packet
0 : OSPF bad checksum
0 : OSPF drop on unnumber interface
0 : OSPF bad authentication type
0 : OSPF packet too small
0 : OSPF transmit error
0 : OSPF unknown neighbor
0 : HELLO: Hello timer mismatch
0 : HELLO: Extern option mismatch
: DD: MTU option mismatch
0 : DD: Extern option mismatch
0 : LS ACK: Unknown LSA type
0 : LS REQ: Bad request
0 : LS UPD: Received less recent LSA
1-15
Description