Enable Snmp Trap Updown - 3Com S7906E Command Reference Manual

Aggregation Interface
Aggregation Mode
System ID
Local:
Port Status Priority Oper-Key Flag
Remote:
Actor Partner Priority Oper-Key SystemID Flag

enable snmp trap updown

Syntax
enable snmp trap updown
undo enable snmp trap updown
View
Layer-2 aggregate interface view
Default Level
2: System level
Parameters
None
Description
Use the enable snmp trap updown command to enable linkUp/linkDown trap generation for the
current aggregate interface.
Use the undo enable snmp trap updown command to disable linkUp/linkDown trap generation for the
current aggregate interface.
By default, linkUp/linkDown trap generation is enabled for an aggregate interface.
Note that for an aggregate interface to generate linkUp/linkDown traps when its link state changes, you
must also enable linkUp/linkDown trap generation globally with the snmp-agent trap enable
[ standard [ linkdown | linkup ] * ] command.
Refer to SNMP Commands in the System Volume for information about the snmp-agent trap enable
command.
Examples
# Enable linkUp/linkDown trap generation on interface Bridge-aggregation 1.
<Sysname> system-view
[Sysname] snmp-agent trap enable
Field
1-8
Description
Name of the aggregate interface
Type of the aggregation group: Static for static
aggregation, and Dynamic for dynamic
aggregation.
Local system ID
Other information of the local end, including the
member ports, port state, port LACP priority,
operational key, and LACP protocol state flags.
Detailed information about the remote end,
including the corresponding local port, port ID,
port LACP priority, operational key, system ID,
and LACP protocol state flags