Sflow Collector Ip; Sflow Enable - 3Com S7906E Command Reference Manual

[Sysname] sflow agent ip 10.10.10.1

sflow collector ip

Syntax
sflow collector ip ip-address [ port portnum ]
undo sflow collector ip ip-address
View
System view
Default Level
2: System level
Parameters
ip-address: IP address of the sFlow collector.
port portnum: Port number of the sFlow Collector, which is in the range 1 to 65535 and defaults to 6343.
Description
Use the sflow collector ip command to specify the IP address and port number of an sFlow collector.
Use the undo sflow collector ip command to remove the specified IP address.
By default, no sFlow collector IP address is specified.
Note that:
The sFlow collector and sFlow agent must not have the same IP address.
Currently, you can specify at most two sFlow collectors, with one as the backup sFlow collector.
sFlow does not work if no sFlow collector IP address is specified.
If only one sFlow collector IP address is specified, sFlow does not work after you execute the undo
sflow collector ip command.
Examples
# Specify the IP address and port number of an sFlow collector.
<Sysname> system-view
[Sysname] sflow collector ip 10.10.10.2 port 6343

sflow enable

Syntax
sflow enable { inbound | outbound }
undo sflow enable { inbound | outbound }
View
Interface view
Default Level
2: System level
1-3