Port Isolation Configuration Commands - 3Com S7906E Command Reference Manual

1

Port Isolation Configuration Commands

Port Isolation Configuration Commands
display port-isolate group
Syntax
display port-isolate group
View
Any view
Default Level
1: Monitor level
Parameters
None
Description
Use the display port-isolate group command to display information about the default isolation group
(isolation group 1).
Examples
# On a single-isolation-group device, display information about the isolation group.
<Sysname> display port-isolate group
Port-isolate group information:
Uplink port support: NO
Group ID: 1
Ethernet2/0/4
Table 1-1 display port-isolate group command output description
Port-isolate group information
Uplink port support
Group ID
Ethernet2/0/4
Ethernet2/0/5
Field
Ethernet2/0/5
Display the information of a port-isolation group
Indicates whether the uplink port is supported.
Isolation group number
Isolated ports in the isolation group
1-1
Description