3Com S7906E Command Reference Manual page 125

View
Any view
Default Level
1: Monitor level
Parameters
None
Description
Use the display link-aggregation summary command to display the summary information of all
aggregation groups.
You may find out that information about the remote system for a static link aggregation group is either
replaced by none or not displayed at all. This is normal because this type of aggregation group is not
aware of its partner.
Examples
# Display the summary information of all aggregation groups.
<Sysname> display link-aggregation summary
Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e267-6c6a
AGG AGG
Interface Mode
-------------------------------------------------------------------------
BAGG1 S
BAGG10 D
Table 1-3 display link-aggregation summary command output description
Aggregation Interface Type
Aggregation Mode
Loadsharing Type
Actor System ID
AGG Interface
AGG Mode
Partner ID
none
0x8000, 000f-e267-57ad
Field
1-5
Select Unselect Share
Ports Ports Type
1 0 NonS
2 0 Shar
Description
Aggregate interface type:
BAGG for a Layer-2 aggregate interface
RAGG for a Layer-3 aggregate interface
Aggregation group type:
S for static link aggregation
D for dynamic aggregation
Loadsharing type:
Shar for load sharing
NonS for non-load sharing
Local system ID
Abbreviated name of the aggregate interface
Aggregation group type