Oam Mode; Reset Oam - 3Com S7906E Command Reference Manual

oam mode

Syntax
oam mode { active | passive }
View
Ethernet port view
Default Level
2: System level
Parameters
active: Specifies the active Ethernet OAM mode.
passive: Specifies the passive Ethernet OAM mode.
Description
Use the oam mode command to set the Ethernet OAM operating mode for an Ethernet port. By default,
an Ethernet OAM-enabled Ethernet port operates in the active Ethernet OAM mode.
Note that:
No Ethernet OAM connection can be established between two Ethernet ports operating in the
passive Ethernet OAM mode.
For an Ethernet OAM-enabled Ethernet port, the Ethernet OAM operating mode cannot be
changed. To do this, you need to disable Ethernet OAM on the port first.
Related commands: oam enable.
Examples
# Configure GigabitEthernet 2/0/1 to operate in the active Ethernet OAM mode.
<Sysname> system-view
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] oam mode active

reset oam

Syntax
reset oam [ interface interface-type interface-number ]
View
User view
Default Level
2: System level
Parameters
interface interface-type interface-number: Specifies a port by its type and number.
1-16