Ring - 3Com S7906E Command Reference Manual

Examples
# Clear the RRPP message statistics of ring 10 in RRPP domain 10.
<Sysname> reset rrpp statistics domain 1 ring 10

ring

Syntax
ring ring-id node-mode { { master | transit } [ primary-port interface-type interface-number ]
[ secondary-port interface-type interface-number ] level level-value | { edge | assistant-edge }
[ edge-port interface-type interface-number ] }
undo ring ring-id
View
RRPP domain view
Default Level
2: System level
Parameters
ring-id: RRPP ring ID, in the range 1 to 64.
master: Specifies the device as the master node of the RRPP ring.
transit: Specifies the device as the transit node of the RRPP ring.
primary-port: Specifies the port as a primary port.
secondary-port: Specifies the port as a secondary port.
interface-type interface-number: Port type and port number.
level-value: RRPP ring level, with 0 representing primary ring and 1 representing subring.
edge: Specifies the device as the edge node of the RRPP ring.
assistant-edge: Specifies the device as the assistant edge node of the RRPP ring.
edge-port: Specifies the port as an edge port.
Description
Use the ring command to configure the node mode of the device and the role of the port accessing the
RRPP ring.
Use the undo ring command to remove the configuration.
Ports connected to an RRPP ring must conform to the following conditions:
The link type of these ports must be trunk.
They must be Layer 2 Ethernet ports, Layer 2 GE ports or Layer 2 aggregate ports.
They must not be member ports of any aggregation group, service loopback group, or smart link
group.
STP, 802.1x, MAC address authentication and Voice VLAN are all disabled on them.
Note that:
RRPP ports cannot be configured if the RRPP ring is enabled.
Make sure the control VLAN exists before configuring the RRPP ring.
1-12