DeviceNet Explicit Messages
Setting Hold/Clear for Communications Errors (Output)
Explicit
Read
message
/write
Setting for
Read Reads whether hold or
Output Sta-
clear is set as the output
tus (Hold or
status after a communi-
Clear) after
cations error for an out-
Communi-
put (No. 1 to 32)
cations
specified by the Instance
Error
ID. The setting can be
read for a specified num-
ber of points.
Setting for
Write Sets whether hold or
Output Sta-
clear is set as the output
tus (Hold or
status after a communi-
Clear) after
cations error for an out-
Communi-
put (No. 1 to 32)
cations
specified by the Instance
Error
ID. The setting can be
set for a specified num-
ber of points.
Note The default setting is for all outputs to be cleared (0).
Function
Service
code
0E Hex
10 Hex
Command
Class
Instance
ID
ID
Attribute
ID
09 Hex
01 to 20
05 Hex
Hex
09 Hex
01 to 20
05 Hex
Hex
Appendix A
Response
Command data
Data
---
1 byte
00 Hex:
Clear
01 Hex:
Hold
1 byte
---
00 Hex: Clear
01 Hex: Hold
475