Temperature Input Terminals
Comparator
2. Select the Tab Page for the input where rate of change is to be set, and
select Rate of Change under the Function Choice heading.
3. To set the sampling cycle, click the Rate of Change Tab and input the de-
sired value for the sampling cycle in the Sampling Rate field.
4. Return to the General Tab, click the Download Button, and then click the
Reset Button to reset the Unit.
5. Click the OK Button and exit the window.
When the High High Limit, High Limit, Low Low Limit, and Low Limit are set in
the Slave, a status flag will be turned ON when a value exceeds the setting
range. The four set values are High High Limit (HH), High Limit (H), Low Low
Limit (LL), and Low Limit (L), and the values are compared with those in Tem-
perature Data 1. (The comparator function cannot be used with Temperature
Data 2.)
The setting range is − 31,500 to 415,000.
Section 7-6
417