Omron DRT2 SERIES DEVICENET SLAVES - OPERATION MANUAL 04-2008 Operation Manual page 402

Temperature Input Terminals
Setting Using the
DeviceNet Configurator
1,2,3...
If the settings are incorrect, the MS Indicator will flash red and the Unit will not
operate. In this case, make the settings again and reset the power supply.
DRT2-TS04P
SW1
OFF OFF
ON OFF
OFF ON
ON ON
If the settings are incorrect, the MS Indicator will flash red and the Unit will not
operate. In this case, make the settings again and reset the power supply.
Note 1. Always set pin 8 to ON if the DIP switch is used to set the ranges. If this pin
is OFF, the DIP switch settings will not be enabled.
2. The DIP switch settings are read when the power is turned ON.
3. The 1/100 display mode and
each input.
4. When the display mode is set to 1/100 display mode with the DIP switch
(pin 5 ON), the connection path must be set with the configurator. Refer to
7-6-2 Temperature Input Terminal Display Modes for details.
If "1/100 display" is not selected in the I/O data in the connection path set-
tings from the Configurator, the temperature data will be 0.
5. When a DRT1-series Temperature Input Terminal (DRT1-TS04T or
DRT1-TS04P) is being replaced with one of these DRT2-series Slaves and
the 1/100 display mode is being used, refer to the following table and set
the appropriate display mode.
SW7
OFF
OFF
ON
Use the following procedure to set the input type for each input using the Con-
figurator.
1. Double-click the icon of the Slave to be set in the Main Window and open
the Edit Device Parameters Window. (From the Maintenance Mode Win-
dow, click the right mouse button over the Slave icon and select Parame-
ters and Edit.)
2. Select the Tab Page for the input where the sensor settings will be set.
SW2 SW3
Always OFF.
°C/°F display settings cannot be set individually for
SW5
OFF Normal display
ON 1/100 display
Not used. DRT1-compatible 1/100 display
Section 7-6
SW4 Input type
PT
JPT
PT2
JPT2
Display mode
381