Omron DRT2 SERIES DEVICENET SLAVES - OPERATION MANUAL 04-2008 Operation Manual page 219

Connector Terminals with Transistors
User Customized
Boards
User Customized Board
Dimensions
198
A board can be created by the user and mounted to the DRT2-@D32BV(-1).
This allows the user to create the required I/O system by placing I/O connec-
tors, relays, and other components as necessary on the board and then
mounting the board to a Board Terminal. The following diagram illustrates
mounting a customized user board to the DRT2-@D32BV(-1).
M4 screws
Stands:
10 mm
recommended
DRT2-@D32BV(-1)
Cut the user customized board to the dimensions shown below.
19.93
80.00±0.20
User customized board (made by user
to user specifications)
Mounted to mate with
MIL connector
User customized board mounting holes
44.75±0.20
4.25±0.20
55.00±0.20
Section 5-6
Recommended connector:
XG4H-4031-1 (from OMRON)