Omron DRT2 SERIES DEVICENET SLAVES - OPERATION MANUAL 04-2008 Operation Manual page 114

Maintenance Information Window
Item
External Load/Sen- ON when the External Load Disconnected Detection or Sen-
sor Disconnected sor Disconnection Detection function is triggered.
Detection
Models supporting External Load Disconnected Detection (for
outputs): DRT2-OD
Screw-less Clamp Terminals
Models supporting Sensor Disconnected Detection (for
inputs): DRT2-ID
less Clamp Terminals
Sensor Power Short- ON when the External Load Short-circuit Detection or Sensor
circuit Detection and Power Short-circuit Detection function is triggered.
External Load Short-
Models supporting this function (for inputs): DRT2-
circuit Detection
@@
ID
Terminals and DRT2-ID16S(-1) and DRT2-MD16S(-1) Sensor
Connector Terminals
(When using a Sensor Connector Terminal, the I/O power sup-
ply to the entire Terminal will be turned OFF if a short circuit is
detected in even one sensor's power supply.)
Operation Time Over ON when the measured operation time exceeds the user-set
monitor value.
Basic models*: DRT2-MD16(-1), DRT2-ID16(-1), and DRT2-
OD16(-1)
Relay output model*: DRT2-ROS16
Sensor Connector models: DRT2-MD16S(-1)
3-tier I/O Terminal Block models: DRT2-
MIL Connector models: DRT2-
@
D32ML(-1),
DRT2-
Screw-less Clamp models: DRT2-
@
D
*This function can be used in these models only when an
Expansion Unit is mounted and the Slave operates as an I/O
Unit.
Description
@@
SLH(-1) and DRT2-MD32SLH(-1)
@@
SLH(-1) and DRT2-MD32SLH(-1) Screw-
SLH(-1) and DRT2-MD32SLH(-1) Screw-less Clamp
@
D32B(-1), and DRT2-
@@
SLH(-1)
Section 5-4
@
D16TA(-1)
@
D16ML(X)(-1), DRT2-
@
D32BV(-1)
@ @@
D SL(-1) and DRT2-
93