Omron DRT2 SERIES DEVICENET SLAVES - OPERATION MANUAL 04-2008 Operation Manual page 120

Remote I/O Terminals with Transistors
Baud Rate Setting
Output Hold/Clear
Setting
Setting Output Hold/Clear from the Configurator
1,2,3...
Note Any node address within the setting range can be used as long as it is not
already set for another node. Setting the same node address for more than
one node will cause a node address duplication error and communications will
not start.
The baud rate of the whole system is determined by the baud rate set for the
Master Unit. Setting the baud rate for each Unit is not required.
Use the Configurator to set the output hold/clear settings. The factory setting
is for outputs to be cleared.
OFF (Clear): When a communications error occurs, all of the output data
ON (Hold):
The Output Hold/Clear setting method is shown below.
1. From the Main Window, open the Network Configuration Window and dou-
ble-click or click the right mouse button over the icon of the corresponding
DRT2-series Smart Slave. Select Parameter and Edit to display the Edit
Device Parameters Window.
From the Maintenance Mode Window, open the Network Configuration
Window in the Configurator and click the right mouse button over the icon
of the corresponding DRT2-series Smart Slave. Select Parameter and
Edit to display the Edit Device Parameters Window.
2. Select the OUT Tab.
3. Double-click the name of the applicable terminal to display the following
window.
from the Master is cleared to 0.
When a communications error occurs, the output data from
the Master is held at its previous status.
Section 5-5
99