Omron DRT2 SERIES DEVICENET SLAVES - OPERATION MANUAL 04-2008 Operation Manual page 327

Overview of Analog Slaves
Analog Output Terminals
Connect the communications cables.
Set the node address using rotary switches or Con-
figurator. (After changing the setting, toggle the pow-
er supply or reset the Unit from the Configurator.
Output range set on the DIP switch?
Yes
Set the output range by turning ON DIP switch pin
8 and using pins 1 to 3 for output 0 or pins 4 to 6
for output 1.
(After changing the setting, toggle the power supply
or reset the Unit from the Configurator.)
Change the setting for Output
Status after Communications
Error?
No
Use Analog Save functions
or maintenance functions?
No
Use defaults and allocate output
values only in the Master.
(Allocate to a fixed area in the Master.)
Fixed allocations
306
No
With the Configurator online, set the output range from
the Slave's Edit Device Parameters Window, download
the settings to the Slave, and reset the Unit.
Yes
With the Configurator online, open the Slave's Edit Device Param-
eters Window, set the Slave to retain outputs after a communica-
tions error, download the settings to the Slave, and reset the Unit.
Yes
With the Configurator online, open the Slave's Edit
Device Parameters Window, select the desired
functions download the settings, and reset the Unit.
Allocate I/O data (patterns)
in the Master?
Yes
With the Configurator online, select the preferred
I/O data pattern from the pull-down menu under
Default Connection Path (In/Out) in the Slave's Edit
Device Parameters Window, download the settings
to the Slave, and reset the Unit.
(Allocate to a user-specified area in the Master.)
User allocations
No
With the Configurator online, set the
Slave's I/O size, select the Slave in the
Master's Edit Device Parameters Window,
and set the connection
(Allocate to a user-specified area in the Master.)
User allocations
Section 7-1