Industry Standard Sensor Connector Assembly, Wiring, And Installation - Omron DRT2 SERIES DEVICENET SLAVES - OPERATION MANUAL 04-2008 Operation Manual

Connector Terminals with Transistors
5-6-2 Industry Standard Sensor Connector Assembly, Wiring, and
Installation
1,2,3...
The DRT2-@D16S(-1) Sensor Connector Terminal uses an industry standard
sensor connector. When connecting the sensor or external device to the Con-
nector Terminal, a special connector must be attached to the sensor or exter-
nal device cable.
OMRON XN2A-1430
Cable Connector
Use the following procedure to attach the Cable Connector to the sensor or
external device cable.
1. Checking the Cable Connector and Cable Wire Size
The applicable Cable Connector depends on the manufacturer and the
wire size. Use the following table to check that the Cable Connector and
sensor or external device cable wire size are compatible.
Tyco Electronics Corporation
Model Housing
color
3-1473562-4 Orange
1-1473562-4 Red
1473562-4 Yellow
2-1473562-4 Blue
4-1473562-4 Green
Sumitomo 3M
Model Housing
37104-3101-000FL Red
37104-3122-000FL Yellow
37104-3163-000FL Orange
37104-2124-000FL Green
37104-2165-000FL Blue
37104-2206-000FL Gray
OMRON
Model Specifications
XN2A-1430 Spring clamp type
Applicable wire range
Sheath outer diameter:
0.6 to 0.9 mm dia.
Sheath outer diameter:
0.9 to 1.0 mm dia.
Sheath outer diameter:
1.0 to 1.15 mm dia.
Sheath outer diameter:
1.15 to 1.35 mm dia.
Sheath outer diameter:
1.35 to 1.60 mm dia.
Applicable wire range
color
AWG26 (0.14 mm
sheath outer diameter: 0.8 to 1.0 mm
AWG26 (0.14 mm
sheath outer diameter: 1.0 to 1.2 mm
AWG26 (0.14 mm
sheath outer diameter: 1.2 to 1.6 mm
AWG22 (0.3 mm
outer diameter: 1.0 to 1.2 mm
AWG22 (0.3 mm
outer diameter: 1.2 to 1.6 mm
AWG22 (0.3 mm
outer diameter: 1.6 to 2.0 mm
Applicable wire range
AWG28 (0.08 mm
sheath outer diameter: 1.5 mm max.
Section 5-6
Cross section:
2
0.08 to 0.5 mm
2 2
) to AWG24 (0.2 mm ),
2 2
) to AWG24 (0.2 mm ),
2 2
) to AWG24 (0.2 mm ),
2 2
) to AWG20 (0.5 mm ), sheath
2 2
) to AWG20 (0.5 mm ), sheath
2 2
) to AWG20 (0.5 mm ), sheath
2 2
) to AWG20 (0.5 mm ),
145