Omron DRT2 SERIES DEVICENET SLAVES - OPERATION MANUAL 04-2008 Operation Manual page 308

Mounting and Wiring Environment-resistive Slaves
DRT2-ID04CL(-1),
DRT2-OD04CL(-1),
DRT2-OD08C(-1),
DRT2-ID08CL(-1),
DRT2-OD08CL(-1),
DRT2-HD16CL(-1),
DRT2-WD16CL(-1)
and DRT2-MD16CL(-1)
Compatible Connectors
Example System Assembly
The internal power supply shares the communications power supply, but the
I/O power supply must be supplied from external power supply connectors.
The DRT1-series Environment-resistive Terminals used I/O power supply
cables with connectors (XS2W-D42@-@8@-@) that are different to the con-
nectors used with the DRT2-series Terminals. Always use the compatible
power supply connectors listed in the following table.
Connector
Cable with connec-
tors on both ends
(socket and plug)
Cable with connector
on one end (female
socket)
Cable with connector
on one end (male
plug)
T-joint
Input power supply
Output power supply
XS4F-D421-1@@-A
Cable with round
waterproof connector
on one end (socket)
Note 1. Tighten the connector by hand to a torque of 0.39 to 0.49 N·m. If the con-
nector is not tightened sufficiently, it will not provide the expected degree
of protection and may become loose due to vibration. Do not use pliers or
other tools to tighten the connectors, because these tools may damage the
connectors.
2. The OMRON S8@@ Power Supply Unit is recommended for the I/O power
supply. The load short-circuit detection function uses the transistor's ther-
XS4W-D421-1@@-A
XS4F-D421-1@@-A
XS4H-D421-1@@-A
XS4R-D424-5
DRT2-ID08CL
XS4W-D421-1@@-A
Cable with round
waterproof connectors
on both ends
I/O power supply
(socket/plug)
XS4R-D424-5
T-joint
XS4W-D421-1@@-A
Cable with round
waterproof connector on
both ends (socket/plug)
Section 6-6
Mode
DRT2-OD08CL
XS4R-D424-5
T-joint
287