Omron DRT2 SERIES DEVICENET SLAVES - OPERATION MANUAL 04-2008 Operation Manual page 310

Mounting and Wiring Environment-resistive Slaves
XS2R-D426-@11-F Y-joint with Plug/Socket (Connector on Both Ends)
15
CN2
35 18
CN1
XS2R-D426-1 Y-joint with Plug/Socket (without Cable)
15
CN2
(37) 18
CN1
Maintaining Enclosure Ratings
45.5
4.6 dia.
8.5
13.6
Blue mark
Note Refer to the Sensor I/O Connector Group Catalog (Cat. No. X073) for details.
27
7
4.5 dia.
24.5
CN0
12.5
58.3
Blue mark
Note Tighten the connector by hand to a torque of 0.39 to 0.49 N·m. If the connec-
tor is not tightened sufficiently, it will not provide the expected degree of pro-
tection and may become loose due to vibration. Do not use pliers or other
tools to tighten the connectors, because these tools may damage the connec-
tors.
Always cap unused connectors with an XS2Z-12 Waterproof Cover or XS2Z-
15 Dust Cover shown in the following diagram.
XS2Z-12 Waterproof Cover
The connector will meet IP67 standards
if a Waterproof Cover is attached.
Always tighten the connector by hand to
a torque of 0.39 to 0.49 N·m.
Note 1. The IP67 enclosure rating will not be met if the surfaces where the contact
block and cover meet are subjected to excessive force. Protect the contact
block and cover from excessive force.
The IP67 standard is lower than waterproof standards. Do not submerge
the system components.
The body of the components is plastic resin. Do not place objects on the
components or allow the components to be stepped on.
2. There are two kinds of wiring for OMRON Two-wire Proximity Sensors
(pre-wired with connector). One switch has IEC pin arrangement (M1GJ
type) and the other has OMRON pin arrangement (M1J type). Refer to the
6 dia.
44.7
L
Press the Dust Cover onto the connector
firmly. The Dust Cover will protect the con-
nector from dust, but does not meet IP67
standards.
Section 6-6
Wiring diagram
1
2
CN2
3
4
1
2
CN1
3
4
Wiring diagram
4
3
CN2
2
1
4
3
CN1
2
1
XS2Z-15 Dust Cover
4
3
2
1
4
3
CN0
2
1
289