Overview of Analog Slaves
Enable or disable the moving
average and scaling functions
6 types of data
Temperature
input value (1)
Peak value
(2)
Bottom value
(3)
Top value
(4)
Valley value
(5)
Rate-of-change
value (6)
300
or "1/100 display mode" and the data can be allocated as "Temperature Data
1" or "Temperature Data 2."
Display mode selector switch
Display mode selector switch
The Comparator function can be
Comparator
used only on the value allocated
as Temperature Data 1.
Analog Status Flags
(Allocated I/O data)
Note The Temperature Data 1 and Temperature Data 2 settings must be set to "nor-
mal display" when using the DRT1-compatible 1/100 display mode. Refer to
7-6-2 Temperature Input Terminal Display Modes for details on the
DRT1-compatible 1/100 display mode.
Temperature Data 1 and Temperature Data can be selected separately with
inputs 0 to 3, as shown in the following diagram.
Input 0
Input 1
Processing
Input 2
Input 3
Processing
1/100 display (2 words/input)
Temperature Data 2
(Allocated I/O data)
Normal display (1 word/input)
Temperature Data 2
(Allocated I/O data)
1/100 display (2 words/input)
Temperature Data 1
(Allocated I/O data)
Normal display (1 word/input)
Temperature Data 1
(Allocated I/O data)
Input value
Processing
Other result
Input value
Other result
Input value
Processing
Other result
Input value
Other result
Section 7-1
Either can be assigned
to the Master as
Temperature Data 2.
Either can be assigned
to the Master as
Temperature Data 1.
Temperature Data 1
Temperature Data 2
Temperature Data 1
Temperature Data 2
Temperature Data 1
Temperature Data 2
Temperature Data 1
Temperature Data 2