Changing The Channel Or Gid - Kenwood NEXEDGE NX-200 Function Reference

3 BASIC OPERATIONS
3.5 Changing the Zone-channel or GID
Mobile
Pressing the Zone Up key increases the zone number in steps of 1. Pressing the Zone Down key decreases the zone
number in steps of 1.
If "Zone Up (Continuous)" or "Zone Down (Continuous)" is assigned to the Zone Up or Zone Down key, the zone number will
be increased or decreased continuously every 200 ms by holding down the Zone Up or Zone Down key.
If an unprogrammed zone is selected, the zone will be skipped.
Note
Operation for changing the zone varies depending on the configuration for Rollover/ End Stop. (Refer to
page 28.)
Configuration using KPG-111D/ DN
• Assigning functions to the PF keys on the transceiver (
• Configuring the 16 Zone/Channel Selector to be enabled or disabled (

Changing the Channel or GID

The channel or GID can be changed using the Selector (Portable only) or PF keys.
Portable
 If 16 Zone/Channel Selector is enabled and the CH/GID Select function is assigned to the Selector
(NX-200/ NX-200S/ NX-300/ NX-300S only)
The Selector can be used with the stopper installed. Rotating the Selector causes the transceiver to migrate to the
channel or GID having the same number specified by the Selector. Channels or GIDs that can be selected are limited
to channel or GID number 1 to Channel or GID number 16.
If an unprogrammed channel or GID is selected, "**************" appears on the main display.
 If 16 Zone/Channel Selector is disabled and the CH/GID Up/Down function is assigned to the
Selector (NX-200/ NX-210/ NX-300/ NX-410/ NX-411 only)
Rotating the Selector clockwise increases the channel or GID number in steps of 1. Rotating the Selector
counterclockwise decreases the channel or GID number in steps of 1.
If an unprogrammed channel or GID is selected, the channel or GID will be skipped.
 Using the PF keys
Pressing the CH/GID Up key increases the channel or GID number in steps of 1. Pressing the CH/GID Down key
decreases the channel or GID number in steps of 1.
If "CH/GID Up (Continuous)" or "CH/GID Down (Continuous)" is assigned to the CH/GID Up or CH/GID Downkey, the
channel or GID number will be increased or decreased continuously every 200 ms by pressing and holding the CH/GID
Up or CH/GID Down key.
If an unprogrammed channel or GID is selected, the channel or GID will be skipped.
Note
• Operation for changing the channel or GID varies depending on the configuration for Rollover/ End Stop. (Refer to
on page 28.)
• For NX-200S/ NX-300S, 16 Zone/Channel Selector is always configured to be enabled.
• For NX-210/ NX-410/ NX-411, 16 Zone/Channel Selector is always configured to be disabled.
FUNC (K)/Ver 4.00
See FPRG 8.12 Key Assignment Window)
See FPRG 8.12.2 General Tab)
CONTENTS
Rollover/ End Stop on
Rollover/ End Stop
INDEX 27