Kenwood NEXEDGE NX-200 Function Reference page 534

25
ADJUSTING THE TIME ON THE TRANSCEIVER
The transceiver is equipped with an internal clock IC. Using the IC, the current time can be viewed on the main display.
The following 3 functions relevant to clock display are available.
• Current Time Display
• Power-on Clock Display
• Time Adjustment
Note
This function is unavailable for NX-200S/ NX-300S.
25.1 Displaying the Current Time
Pressing the Clock key results in the current time appearing on the main display.
The current time also appears when "Clock" is selected after entering Menu Mode by pressing the Menu key. (Refer to
Using Menu Mode on page
Operating the Transceiver
1
Press the Clock key.
The current time appears.
Note
• If Clock Display is enabled, the current time appears on the main display when the transceiver is turned ON.
• The transceiver is equipped with a separate battery for the clock IC. If the rechargeable battery runs out, the clock will not be displayed
properly. In this case, the battery must be recharged and then the clock can be configured again. In this case, "- - : - -" appears.
FUNC (K)/Ver 4.00
23.)
• 12H Display
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
• 24H Display
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
CONTENTS
3.4
INDEX 500