Kenwood NEXEDGE NX-200 Function Reference page 439

16 COMMUNICATIONS IN AN EMERGENCY
16.6 Placing the Transceiver Automatically in Emergency Mode
Operating the Transceiver
 Placing the transceiver in Lone Worker Mode
1
Do either of the following operations while the transceiver is not in Lone Worker Mode.
• Press the Lone Worker key.
• Select a channel or GID where Lone Worker is enabled.
• Press the Menu key to enter Menu Mode, and select "Lone
Worker" and then select "ON".
The " " icon appears, the transceiver enters Lone Worker
Mode, and then the timer for Lone Worker Interval starts counting
down. The Key Beep A sounds from the transceiver by pressing
the Lone Worker key.
If no key is pressed after the timer for Lone Worker Interval starts counting down, the Lone Worker Tone sounds from the
transceiver when the time configured for Lone Worker Interval elapses. The Lone Worker Tone sounds for the time
configured for Duration of Lone Worker Tone. If no key is pressed while the Lone Worker Tone continues to sound from the
transceiver, and if the time configured for Duration of Lone Worker Tone elapses, the transceiver enters Emergency Mode.
The transceiver behaves according to the configuration of Emergency after the transceiver enters Emergency Mode.
(Refer to 16 COMMUNICATIONS IN AN EMERGENCY on page
FUNC (K)/Ver 4.00
Emergency Mode
Duration of Lone
Worker Tone
Lone Worker
Interval
Transmit (PTT)
Figure 16-2 Lone Worker Mode (Portable)
Emergency Mode
Duration of Lone
Worker Tone
Lone Worker
Interval
Transmit (PTT)
Figure 16-3 Lone Worker Mode (Mobile)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
393.)
Sounds the
Lone Worker Tone
Time
Sounds the
Lone Worker Tone
Time
AUX Port (except
External PTT (Voice))
PC Command
CONTENTS
Mobile
INDEX 405