Kenwood NEXEDGE NX-200 Function Reference page 351

12 FleetSync
12.4 Making a Selective Call
Restricting IDs for Which the Transceiver Can Initiate a Call (Unit ID Encode Block)
Unit ID Encode Block is the FleetSync ID range used to initiate a call.
A FleetSync ID with which a user is allowed to initiate a call can be restricted using KPG-111D/ DN. The user can use the
FleetSync ID stored in the ID List even if it is outside the Unit ID Encode Block range.
The transceiver for which no Unit ID Encode Block is configured can initiate a call to all transceivers.
Following are available FleetSync IDs.
Unit ID Encode
Block
Enabled Unit ID Encode Block in all Fleets
Disabled All Fleet IDs
Configuration using KPG-111D/ DN
Configuring the Unit ID Encode Block (
Interfleet Call
Interfleet Call can be used to initiate a call using a FleetSync ID having a different fleet number.
If Interfleet Call is disabled, a call to a FleetSync ID having a different fleet number can be inhibited. This function also
prevents a user who does not use Interfleet IDs from initiating a call by selecting an Interfleet ID accidentally.
Note
• An Interfleet Call can be initiated regardless of this function's configuration, if the Interfleet Call is initiated with the PC Command.
• For NX-200S/ NX-300S, an Interfleet Call cannot be initiated by selecting a FleetSync ID from the ID List or directly entering a
FleetSync ID, but an Interfleet Call can be initiated by using the Call 1 to Call 6 keys and the PTT ID.
• For NX-200S/ NX-300S, an Interfleet Call cannot be prevented by using this function.
Configuration using KPG-111D/ DN
Configuring the Interfleet Call to be enabled or disabled (
Auto Reset Timer
Auto Reset Timer counts down the amount of time from when the received FleetSync ID matches the FleetSync ID (Own)
preconfigured for the transceiver until the matching status is automatically reset. The matching state means that a user
can communicate only using QT tone or DQT code after the FleetSync ID is matched.
By using KPG-111D/ DN, Auto Reset Timer can be configured. Also, how the transceiver behaves after the amount of time
configured for Auto Reset Timer elapses can be configured.
FUNC (K)/Ver 4.00
Table 12-8 Available FleetSync IDs
Interfleet Call Configuration
On (Check)
See FPRG 8.16.2 General 1 Tab)
FPRG 8.16.2 General 1 Tab)
See
Off (Uncheck)
Unit ID Encode Block in Own Fleet
All IDs in Own Fleet
CONTENTS INDEX 317