Initiating Voice Communications (Basic Transmission And Reception); About Own Id; Receiving; Auto Reset Timer - Kenwood NEXEDGE NX-200 Function Reference

8 NXDN CONVENTIONAL SYSTEM

8.1 Initiating Voice Communications (Basic Transmission and Reception)

8.1 Initiating Voice Communications
(Basic Transmission and Reception)
This section describes the basic methods for transmission and reception in an NXDN Conventional system and the
relevant functions.

About Own ID

To initiate various communications using NXDN, a Unit ID (Own), the identification code of a transceiver, needs to be
configured for the transceiver.
One Unit ID (Own) can be configured for each transceiver. Also, a name specific to the transceiver can be configured for
Unit ID (Own).
Note
If the transceiver is operated in multiple systems of an NXDN Trunking system, the Unit ID (Own) configured in the Home System is
used as the own ID. (Refer to
Configuration using KPG-111D/ DN
Configuring the Unit ID (Own) and the Unit ID Name (Own) (

Receiving

Received audio sounds from the speaker if the transceiver receives digital signals, and the frequency matches the
frequency of the channel on which the transceiver has waited for or the NXDN ID matches the NXDN ID preconfigured for
the transceiver. When a signaling (RAN) is used, communications are possible if the received RAN code matches the RAN
code which the transceiver waits for.

Auto Reset Timer

Auto Reset Timer is the amount of time from when the received Unit ID or Group ID matches the Unit ID or Group ID
preconfigured for the transceiver until the LCD, blinking of LED and emission of Alert Tone will automatically be reset.
By using KPG-111D/ DN, Auto Reset Timer can be configured. Also, how the transceiver behaves after the amount of time
configured for Auto Reset Timer elapses can be configured.
Configuration
Off Auto Reset Timer will not be activated.
1 s to 300 s After the configured time elapses, the matching state of the Unit ID or Group ID is automatically reset.
If this function is enabled, the blinking orange Busy LED for the Selective Call Alert LED turns Off when the time
LED
configured for the Auto Reset Timer elapses.
While this function is enabled, the intermittently emitted Alert Tone stops if the amount of time configured for Auto
Alert Tone
Reset Timer elapses.
While this function is enabled, the display will change from one of the following displays to the previous channel
display if the amount of time configured for Auto Reset Timer elapses.
• ID display after receiving an Individual Call or Group Call
• Status Message display after receiving a Status Message
LCD
• Short Message display after receiving a Short Message
Note
This function is unavailable for NX-200S/ NX-300S.
FUNC (K)/Ver 4.00
9 NXDN TRUNKING SYSTEM on page
Table 8-1 Auto Reset Timer
187.)
FPRG 8.19.2 General 1 Tab)
See
Description
CONTENTS INDEX 110