Kenwood NEXEDGE NX-200 Function Reference page 158

8 NXDN CONVENTIONAL SYSTEM
8.4 Using NXDN ID to Initiate a Selective Call
Note
• Conditions for unmuting the speaker vary depending on the Audio Control configuration. (Refer to
Control (NXDN)) on page 119,
• While the transceiver is in Emergency Mode, the transceiver transmits according to the configuration for Transmit Mode.
• If the transceiver receives FleetSync data, the transceiver will send an acknowledgment in analog mode, and if the transceiver
receives NXDN data, the transceiver will send the acknowledgment in digital mode. The transceiver transmits according to the
configuration for Transmit Mode after the transceiver completes data communications regardless of the configuration for Signaling
Reset Timer or Auto Reset Timer.
• In FleetSync data communications, if the transceiver receives data by means of a call other than Individual Call, namely Fleet Call,
Group Call, Supervisor Call or Broadcast Call, the transceiver transmits in analog mode while the speaker opens during the length of
time from when the transceiver receives data until the time configured for Signaling Reset Timer elapses regardless of the
configuration for Transmit Mode.
• If "OFF" is configured for Signaling Reset Timer, the transceiver retains the status of transmitting in the same mode as the received
signal. This status will be reset by an operation such as changing a channel.
• If "0" is configured for Signaling Reset Timer, the transceiver transmits according to the configuration for Transmit Mode.
Configuration using KPG-111D/ DN
• Configuring the Channel Type and the Transmit Mode (
• Configuring the Signaling Reset Timer (
8.4 Using NXDN ID to Initiate a Selective Call
An individual call and group call are available by using NXDN IDs. In addition, a message can be sent to a specified target
ID in various types of message communications.
Available Calls
The following various types of calls can be used in an NXDN Conventional system. For transceiver operations and
behaviors, refer to the instructions of each call type.
• Individual Call
• Individual Call (Individual Call Acknowledge Request)
• Group Call
• Status Call
• Short Data Call
• Long Data Call
Transition for Each Mode
If a user wishes to send or receive an Individual Call, Group Call, Status Message, or Short Message, the user must
operate the transceiver after selecting the desired mode. Following are the transition diagrams for each mode.
FUNC (K)/Ver 4.00
Unmuting the Speaker (Audio Control (Analog)) on page
See FPRG 8.10.1 Common Page 1 Tab)
261.)
FPRG 8.3.3 Page 1 Tab)
See
CONTENTS
Unmuting the Speaker (Audio
INDEX 124