Kenwood NEXEDGE NX-200 Function Reference page 214

8 NXDN CONVENTIONAL SYSTEM
8.15 Sending GPS Data
Configuration using KPG-111D/ DN
• Configuring the Base ID Type and the Base ID (
• Configuring the Base ID Type (GPS) and Base ID (GPS) (
Sending GPS Data Automatically at Certain Intervals (GPS Report Mode)
GPS data can be sent automatically at the intervals configured for GPS Report Interval.
This function is used for controlling or monitoring vehicles on a time basis by periodically transmitting location information
to the base station.
To use this function, "Auto" must be configured for GPS Report Mode by using KPG-111D/ DN.
Note
• The transceiver sends the GPS data upon receipt of the GPS data transmission request from the base station even if "Auto" is
configured for GPS Report Mode.
• If the transceiver is under the following conditions, the automatic transmission of GPS data at certain intervals will be canceled. Also,
the Transmit Busy Wait Time will not suspend the transmission to avoid a collision with a GPS transmission from another transceiver
while sending GPS data. (Refer to
• If the transceiver is transmitting
• While the transceiver is in busy state
• While the transceiver unmutes the speaker
• While the Public Address function is used (Mobile only)
• If Transmit Frequency is not configured or "Receive Only" is configured for ID Mode
• If transmission is disabled by the Time-out Timer
• While the transceiver is sending or receiving the NXDN data
• While the transceiver is connected to the repeater
• Transceiver Password Mode
• Emergency Mode
*1
However, since Data with Voice is activated while the voice data is sent, the transmission of GPS data will not be canceled.
Configuration using KPG-111D/ DN
Configuring the GPS Report Mode (
Sending GPS Data According to the Request from the Base Station
(GPS Report Mode)
The transceiver can send GPS data when a GPS data transmission request is received from the base station.
This function is used when the base station controls the timing to require GPS data. This function is also used to avoid
transmit collisions if there are many subscriber units.
To use this function, "Poll" must be configured for GPS Report Mode by using KPG-111D/ DN.
Note
The transceiver sends GPS data to the ID configured for Base ID (GPS) or Base ID, not to the ID that sent the data transmission
request.
Configuration using KPG-111D/ DN
Configuring the GPS Report Mode (
FUNC (K)/Ver 4.00
See FPRG 8.19.2 General 1 Tab)
Transmit Busy Wait Time on page
*1
See FPRG 8.11.4 GPS Tab)
See FPRG 8.11.4 GPS Tab)
See FPRG 8.19.10 GPS Tab)
147.)
CONTENTS INDEX 180