Kenwood NEXEDGE NX-200 Function Reference page 418

15
GPS
Global Positioning System (GPS) is the system to acquire the current location information of the own transceiver by
receiving signals from the Global Positioning System satellites orbiting the earth.
GPS data can be communicated by using the NXDN or FleetSync protocol.
Refer to the following for information on the transmission behavior for each protocol and behavior sending received GPS
data to a PC as serial commands.
 NXDN
8.15 Sending GPS Data on page
 FleetSync
12.9 Sending GPS Data on page
This chapter describes common functions relevant to sending GPS data and the GPS Position Display function used to
show the current location information of the own transceiver on the LCD.
15.1 GPS Functions
The following functions are relevant to GPS data transmission.
• Number of Times
• GPS Report Interval Time
• GPS Time Mark
• GPS Message Type
• GPS Report on Data Zone-CH/GID
• GPS Data Storage
• GPS Report CH/GID
• GPS Report Back to Requested ID
• GPS ACK Request
Number of Times
Number of Times allows the transceiver to automatically send GPS data for the configured number of times if "Poll" is
configured for GPS Report Mode.
The transceiver sends GPS data for the number of configured times at the intervals configured for GPS Report Interval.
Configuration using KPG-111D/ DN
Configuring the Number of Times (
GPS Report Interval Time
GPS Report Interval Time allows the transceiver to send GPS data at the configured intervals if "Auto" is configured for
GPS Report Mode.
GPS Report Interval Time (Portable/Ignition On)
GPS Report Interval (Portable/Ignition On) is the interval to send the GPS data while the vehicle's engine is running. In
order to automatically transmit GPS data in Portable, this configuration is used.
FUNC (K)/Ver 4.00
179, 8.16 Receiving GPS Data on page 183
344, 12.10 Receiving GPS Data on page 348
See FPRG 8.11.4 GPS Tab)
in "8 NXDN CONVENTIONAL SYSTEM"
in "12 FLEETSYNC"
CONTENTS INDEX 384