Kenwood NEXEDGE NX-200 Function Reference page 194

8 NXDN CONVENTIONAL SYSTEM
8.9 Sending and Receiving a Status Message (Status Call)
Configuration using KPG-111D/ DN
Configuring the Power-on Status Message (
Power-off Status Message
Power-off Status Message allows the transceiver to send the selected Status Message when the transceiver is turned OFF.
Using the Power-off Status Message, the base station can recognize that the transceiver has been turned OFF. The
transceiver sends the message to the ID configured for Base ID.
Note
• In an NXDN Trunking system, the transceiver ends a transmission without sending the Power-off Status again if the transceiver fails to
send the Power-off Status.
• In an NXDN Trunking system, the transceiver does not transmit the Power-off Status if the transceiver cannot acquire the control
channel when the transceiver is turned OFF.
Configuration using KPG-111D/ DN
Configuring the Power-off Status Message (
Base ID
Base ID is the target transceiver's ID used to send GPS data or Transparent data and the following Status Messages and
Short Messages.
• AUX Input Status Message (Mobile only)
• Power-on Status Message
• Power-off Status Message
• A Status Message that is sent by selecting a status number or directly entering a status number after the
transceiver enters Status Mode by a user pressing the Status (FleetSync/NXDN) key or the [0] to [9] keys on the
keypad
• A Status Message that is sent by selecting a status number or directly entering a status number after the
transceiver enters Status Mode by a user selecting "Status (FleetSync/NXDN)" from Menu Mode
• A Status Message that is sent by a user pressing the Call key
• A Short Message that is sent by entering a text string after the transceiver enters Short Message Mode by a user
pressing the SDM (FleetSync/NXDN) key or the [0] to [9] keys on the keypad
• A Short Message that is sent by entering a text string after the transceiver enters Short Message Mode by a user
selecting "SDM (FleetSync/NXDN)" from Menu Mode
Base ID can be configured using KPG-111D/ DN. Either Unit ID or Group ID can be configured. ID of the base station that
manages operations is normally configured for Base ID.
Note
• In an NXDN Conventional system, the Base ID Type and Base ID configured in the Home System when the transceiver is operated in
multiple systems of an NXDN Trunking System are used. (Refer to
• In multiple systems of an NXDN Trunking system, Base ID Type and Base ID can be configured for each system. (Refer to
TRUNKING SYSTEM on page
Configuration using KPG-111D/ DN
• Configuring the Base ID Type and the Base ID (
• Configuring the Base ID Type and the Base ID (Multiple Systems) (
FUNC (K)/Ver 4.00
See FPRG 8.19.9 Status Tab)
FPRG 8.19.9 Status Tab)
See
187.)
See
9 NXDN TRUNKING SYSTEM on page
FPRG 8.19.2 General 1 Tab)
See FPRG 8.20.3 General Tab)
CONTENTS
187.)
9 NXDN
INDEX 160