Kenwood NEXEDGE NX-200 Function Reference page 231

9 NXDN TRUNKING SYSTEM
9.2 Control Channel Hunt
Configuration using KPG-111D/ DN
Configuring the Last Control Channel to be enabled or disabled (
Starting the Control Channel Hunt Manually (Forced Search)
Forced Search allows a user to manually start the test to acquire another control channel providing better conditions while
the transceiver is in the idle state after acquiring a control channel.
Following are hunt sequences to be used by Forced Search. (Refer to
• Preferential Hunt Sequence
• Normal Hunt Sequence
• System Add Channel Sequence
• Site Hunt Sequence
• Comprehensive Hunt Sequence
Operating the Transceiver
 NX-200S/ NX-300S
1
Press and hold the
Search Mode Tone sounds from the transceiver, and then the transceiver will start the Forced Search.
The transceiver leaves the acquired control channel and starts the hunt sequence, and then the transceiver proceeds to
search for another control channel using the Preferential Hunt Sequence. If a control channel is found, the transceiver
migrates to that control channel. In such a case, the transceiver is in the standby state after processing an acquisition of
control channel. If no control channel is found, the transceiver continues the hunt sequence.
 Other than NX-200S/ NX-300S
1
Press the Forced Search
The site number of the current control channel appears for 2 sec.
Note
Transceiver operation is identical even if "Site No." is selected after entering Menu Mode by pressing the Menu key.
(Refer to 3.4 Using Menu Mode on page
FUNC (K)/Ver 4.00
Forced Search key.
key.
23.)
See FPRG 8.25.4 Last Control Channel)
Table 9-2 Hunt Sequence on page
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
CONTENTS
194.)
Mobile
INDEX 197