Kenwood NEXEDGE NX-200 Function Reference page 558

APPENDIX
Available Functions for COM Port
Available Functions for COM Port
Portable
Portable has the following 2 communication ports:
 COM port 0
The COM port 0 is assigned to the 14-pin universal connector (TXD: Pin No.12/ RXD: Pin No.13).
 COM port 1
The COM port 1 is assigned to the 26-pin connector in the transceiver (TXD: Pin No.4/ RXD: Pin No.3).
The following functions can be assigned to communication ports using KPG-111D/ DN.
Range
None
Data
GPS
Data + GPS Data Output
Transparent
Transparent 2 (NXDN)
Mobile
Mobile has the following 3 communication ports:
 COM port 0
The COM port 0 is assigned to the microphone jack on the front panel. (TXD: Pin No.4/ RXD: Pin No.7)
 COM port 1
The COM port 1 is assigned to the 25-pin connector on the rear panel. (TXD: Pin No.3/ RXD: Pin No.2)
 COM port 2
The COM port 2 is assigned to the 25-pin connector on the rear panel. (TXD: Pin No.9/ RXD: Pin No.10)
The following functions can be assigned to communication ports using KPG-111D/ DN.
FUNC (K)/Ver 4.00
Table 1-5 Available Functions for COM Ports
COM port 0
The transceiver can communicate with KPG-111D/ DN.
The transceiver can remotely be controlled using PC Commands.
The transceiver can communicate with KPG-111D/ DN.
Position data can be acquired from the GPS receiver unit. Also, the transceiver can send the received
GPS data when the transceiver receives the GPS data from another transceiver.
The transceiver can communicate with KPG-111D/ DN.
The transceiver can remotely be controlled using PC Commands.
The transceiver will send GPS data by adding STX and ETX when the transceiver receives GPS data
from another transceiver.
The transceiver can communicate with KPG-111D/ DN.
The port functions as the data communication port for the Transparent data communication using
FleetSync protocol and NXDN protocol.
The transceiver can communicate with KPG-111D/ DN. However, on the COM port 0, the transceiver can
communicate only for 10 sec after the transceiver is turned ON.
The port functions as the data communication port for the Transparent data communication using NXDN
protocol which the communication method is optimized. By using Transparent 2 (NXDN), data can be
sent more efficiently than using Transparent.
The transceiver can communicate with KPG-111D/ DN. However, on the COM port 0, the transceiver can
communicate only for 10 sec after the transceiver is turned ON.
Communication Ports
CONTENTS
COM port 1
INDEX 524