Sending And Receiving A Long Message; Sending A Long Message - Kenwood NEXEDGE NX-200 Function Reference

12 FleetSync
12.8 Sending and Receiving a Long Message (Long Data Call)
12.8 Sending and Receiving a Long Message (Long Data Call)
Long Message allows the transceiver to send and receive a maximum of 4,096 characters.
Using this function, information can reliably be sent to the target party.
Note
• To send a Long Message, "Data" or "Data + GPS Data Output" must be configured for the communication port of the transceiver.
(Refer to Available Functions for COM Port on page
• To use serial communications, a user must prepare FleetSync compatible software or external devices.

Sending a Long Message

A Long Message is sent via a PC. A Long Message cannot be sent from the transceiver.
Transceiver Behavior
1
A PC sends the PC command to the transceiver to request transmission of a Long Message.
The transceiver starts sending the Long Message.
If the Long Message is properly sent to the receiving transceiver,
"COMPLETE" appears.
FUNC (K)/Ver 4.00
524.)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
CONTENTS INDEX 342