Kenwood NEXEDGE NX-200 Function Reference page 177

8 NXDN CONVENTIONAL SYSTEM
8.7 Making a Group Call
Transceiver Behavior
1
The transceiver receives a Group Call.
Alert Tone (Group Call) sounds from the transceiver, and then the
received Group ID, or the Unit ID of the transmitting transceiver,
or both will appear. (Refer to
Receives a Group Call (Group Call Display Type) on page
The transceiver can respond to the received Group ID by a user
pressing the PTT switch. When a key other than the PTT switch
is pressed, the configured function will be activated. However,
functions that can be used are limited. When an invalid key is
pressed, the Key Beep B sounds, and then the display will restore
to normal state. Refer to
available functions.
Note
• The transceiver can record the receipt of a Group Call. The record can be checked in Stack Mode. (Refer to
History (Stack) on page 38.)
• When the transceiver receives the Group ID for which "ALL" is configured, the transceiver can respond using the Group ID if the
received Group ID is configured in the Group ID List. If no Group ID is configured in the ID List, the receiving transceiver can receive a
call but the receiving transceiver cannot respond to the call. In this case, the ID Name of the transmitting transceiver does not appear
even if Over-the-Air Alias is enabled. (Refer to
• The transceiver can send the ID of the transmitting transceiver from the communication port on the transceiver when receiving a Group
Call.
• If GID Scan (NXDN) is enabled, the transceiver is on standby to receive a Group Call from all Group IDs configured for the Group ID
List in an NXDN Conventional system. (Refer to
• If the received Group ID is configured in the Group ID List, an Alert Tone sounds from the transceiver according to the configuration of
the corresponding Group ID. If the received Group ID is not registered in the Group ID List, the Alert Tone sounds from the transceiver
according to the configuration for Alert Tone (Group Call) which is commonly used.
Configuration using KPG-111D/ DN
• Configuring the Alert Tone (Group ID List) (
• Configuring the Alert Tone (Group Call) which is commonly used (
FUNC (K)/Ver 4.00
Display When the Transceiver
Mode Reset Timer on page 20
Over-the-Air Alias on page
GID Scan (NXDN) on page
See FPRG 8.19.7 Group ID List Tab)
144.)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
for the
111.)
145.)
See FPRG 8.19.5 Conventional Tab)
Mobile
3.7 Viewing the Receive
CONTENTS INDEX 143