Kenwood NEXEDGE NX-200 Function Reference page 345

12 FleetSync
12.4 Making a Selective Call
2
Press the Up or Down
to select the target data from ID List.
Refer to Selecting or Clearing Data from a List on page 42
selection methods.
3
Press the PTT switch to initiate a Voice Call.
In order to initiate a Paging Call, the Side 2 key (NX-200/
NX-210/ NX-300/ NX-410/ NX-411) or the Square key (Mobile)
needs to be pressed.
Press the Menu ([ ]) or [*] key to enter the Status Message or
Short Message. (Only if the transceiver enters Selcall Mode by a
user pressing the Selcall + Status (FleetSync) or Selcall + SDM
(FleetSync) key or selecting Selcall + Status (FleetSync) or
Selcall + SDM (FleetSync) by pressing the Menu key.) (Refer to
12.6 Sending and Receiving a Status Message (Status Call) on
page 323.)
 Initiating a Selective Call using Manual Dialing
To initiate a Selective Call using Manual Dialing, Manual Dialing must be enabled using KPG-111D/ DN.
1
Press the Selcall (FleetSync),
The transceiver enters Selcall Mode and then the ID List
selection display appears.
The following operations are identical even if the transceiver
enters Selcall Mode by a user pressing the Menu key or with
keypad entry.
FUNC (K)/Ver 4.00
key (NX-200/ NX-210/ NX-300/ NX-410/ NX-411), or press the
Selcall + Status (FleetSync), or
for
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Selcall + SDM (FleetSync)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
CONTENTS
[ ] or [ ] key (Mobile)
Mobile
key.
Mobile
INDEX 311