Viewing The Receive History (Stack) - Kenwood NEXEDGE NX-200 Function Reference

3 BASIC OPERATIONS

3.7 Viewing the Receive History (Stack)

3.7 Viewing the Receive History (Stack)
A received Selective Call, Status Message, or Short Message is stored in the Stack Memory. The message can be
confirmed or deleted by operating the transceiver.
In order to store the received ID or various message in the stack memory of the transceiver, Caller ID Stack, Status
Message Stack, or Short Message Stack must individually be enabled by using KPG-111D/ DN.
The " " icon appears if messages are stored in the transceiver. If there is an unread message, the "
Pressing the Stack key causes the transceiver to enter Stack Mode. Or, pressing the Menu key causes the transceiver to
enter Menu Mode, and then selecting "Stack" will cause the transceiver to enter Stack Mode. (Refer to
Mode on page 23.)
Note
• This function is unavailable for NX-200S/ NX-300S.
• Following are the notes only for an NXDN Conventional system and NXDN Trunking system.
• If the PTT switch is pressed while a Caller ID appears, the transceiver can respond to the Caller ID. If "Analog" is configured for
Transmit Mode of the channel to be used for transmission, a Warning Tone A sounds from the transceiver by a user pressing
the PTT switch, and the transceiver cannot respond.
• If the transceiver receives a Group Call from a telephone, the Caller ID appears by substitution of "PHONE CALL" and the
Caller ID is stored in the stack memory of the transceiver.
• The Caller ID stored if the transceiver receives a Group Call cannot be called.
Operating the Transceiver
 Confirming the message
1
Press the Stack key.
The transceiver enters Stack Mode. The subsequent operations
are identical even if the transceiver enters Stack Mode by a user
pressing the Menu key.
The type and number of the stored message appear at the upper right of the display.
The display varies as follows depending on the message type.
FUNC (K)/Ver 4.00
Table 3-7 Stack Mode
Message Type
Selective Call (Caller ID)
Status Message
Short Message
" icon blinks.
3.4 Using Menu
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
Mobile
Display
I
S
M
CONTENTS INDEX 38