Kenwood NEXEDGE NX-200 Function Reference page 306

10 ANALOG CONVENTIONAL SYSTEM
10.4 Using 2-tone to Initiate a Selective Call
Gap Time
Gap Time is the unmodulated duration between the 1st Tone and 2nd Tone when sending the 2-tone code configured in
the 2-tone Encode Memory List.
Gap Time can be configured using KPG-111D/ DN. Normally, 0 ms is configured for Gap Time.
Configuration using KPG-111D/ DN
Configuring the Gap Time (
First Tone Delay Time
First Tone Delay Time is delay time from when the transceiver starts transmitting until the transceiver actually starts
transmitting the 2-tone code.
The transceiver transmits an unmodulated signal until the amount of time configured for First Tone Delay Time elapses.
Configuration using KPG-111D/ DN
Configuring the First Tone Delay Time (
Sidetone
Sidetone is the function to emit the tone of the 2-tone code from the speaker while the transceiver transmits the 2-tone
code.
Configuration using KPG-111D/ DN
Configuring the Sidetone to be enabled or disabled (
2-tone Encode Memory List
2-tone Encode Memory List is the code list used for transmitting the 2-tone code. The transceiver transmits the 2-tone
code when a code configured in the list is selected.
The following functions can be configured in the 2-tone Encode Memory List.
Configuration
The code to be sent can be configured for each list number as a Single Tone. 2nd Tone cannot be configured if
Single Tone
Single Tone is configured.
2-tone Name 2-tone Name can be used to assign a name to each list number. A maximum of 14 characters can be configured.
The 1st Tone frequency can be configured. The frequency can be configured in the range between 288.5 Hz and
1st Tone
3106.0 Hz inclusive.
The 2nd Tone frequency can be configured. The frequency can be configured in the range between 288.5 Hz and
2nd Tone 3106.0 Hz inclusive.
2nd Tone cannot be configured if Single Tone is configured.
Configuration using KPG-111D/ DN
Configuring the 2-tone Encode Memory List (
FUNC (K)/Ver 4.00
See FPRG 8.15.1 Encode Tab)
FPRG 8.15.1 Encode Tab)
See
See
Table 10-7 Autodial List Configuration
See FPRG 8.15.1 Encode Tab)
FPRG 8.15.1 Encode Tab)
Description
CONTENTS INDEX 272