Changing The Zone; Changing The Channel; Changing The Channel By Specifying The Number (Channel Entry) - Kenwood NX-240 Function Reference

3 BASIC OPERATIONS
3.4 Changing the Zone/ 3.5 Changing the Channel
3.4

Changing the Zone

To change a zone, a PF key can be used.
Pressing the Zone Up key or the Zone Down key while Zone 1 is selected changes the zone to Zone 2. Pressing the
Zone Up key or the Zone Down key again changes the zone to Zone 1.
Note
For Mobile, a Minimum Ch Beep sounds from the transceiver when the minimum zone number is selected.
Configuration using KPG-169D/ KPG-170D/ KPG-175D
Assigning functions to the PF keys (
3.5

Changing the Channel

Portable
To change a channel, the Selector can be used.
Rotating the Selector causes the transceiver to migrate to the channel having the same number specified by the Selector.
The transceiver behavior when a Zone-channel is changed varies according to the configurations for Voice Announcement
and Zone Type. (Refer to 3.6 Transceiver Behavior When the Zone-channel Is Changed on page
If an unprogrammed channel is selected, a Blank Channel Tone sounds from the transceiver and the LED blinks orange
while the channel is selected.
Mobile
Pressing the Channel Up key increases the channel number in steps of 1. Pressing the Channel Down key decreases the
channel number in steps of 1.
If "Channel Up (Continuous)" or "Channel Down (Continuous)" is assigned to the Channel Up or Channel Down key, the
channel number will be increased or decreased continuously by holding down the Channel Up or Channel Down key.
The transceiver behavior when a Zone-channel is changed varies according to the configurations for Voice Announcement
and Zone Type. (Refer to 3.6 Transceiver Behavior When the Zone-channel Is Changed on page
If an unprogrammed channel is selected, the channel will be skipped.
Note
For Mobile, a Minimum Ch Beep sounds from the transceiver when the minimum channel number is selected.

Changing the Channel by Specifying the Number (Channel Entry)

Supported Models: Mobile
Channel Entry can be used to directly migrate to the channel a user wishes to use.
For use of this function, the transceiver needs to enter Channel Entry Mode by pressing the Channel Entry key.
After pressing the Channel Entry key, a channel in the selected zone can be specified by selecting the channel number by
pressing the [ ] or [ ] key or the [<B] or [C>] key, or by directly entering the channel number.
Also, if "Channel Entry" is configured for Keypad Operation, a channel can be specified by pressing the [0] to [9] keys on
the microphone keypad even if the Channel Entry key is not pressed.
FUNC (K)/Ver 1.20
Edit > Key Assignment)
See
14.)
14.)
CONTENTS INDEX 12